Clear (Mep Attribute) - Allied Telesis IE220 Series Manual

C F M
ONNECTIVITY AULT ANAGEMENT
(MEP A )
CLEAR TTRIBUTE

clear (MEP Attribute)

Overview Use this command to clear a Local MEP attribute.
clear {ccm-ltm-priority|lowest-priority-defect|fng-alarm-time
Syntax
|reset-fng-time|active|all}
Mode Interface Ethernet CFM MEP Configuration
Example To set the active state of the Local MEP to False, use the commands:
awplus(config)#
awplus(config-if)#
MD-INST2 ma-name MA-INST2-1
awplus(config-if-eth-cfm-mep)#
Related ethernet cfm domain-name
commands
ethernet cfm mep
mep (FNG attributes)
service ma-name
Command Version 5.4.7-1.1: command added
changes
Version 5.4.8-0.2: added to SBx8100 series products
Version 5.4.8-1.1: added to SBx908 GEN2 series products
C613-50644-01 Rev B
C
OMMANDS
Parameter
ccm-ltm-priority Set the queuing and p-bit priority for CCM messages to their
lowest-priority-
defect
fng-alarm-time
reset-fng-time
active
all
interface port1.0.2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
default value of 7.
Set the Fault Notification Generation (FNG) lowest alarm
priority defect to the default value of 2.
Set the Fault Notification Generation (FNG) time for a defect to
be present before an alarm is raised to the default value of 2.5
seconds.
Set the Fault Notification Generation (FNG) time for a defect to
abate before an alarm is cleared to the default value of 10
seconds.
Set the Local MEP's Active state to the default value of False,
which sets the Local MEP's Administrative State to Down.
Set all of the above attributes to their default values.
ethernet cfm mep down mpid 12 domain-name
clear active
317