Allied Telesis IE220 Series Manual page 520

S C
WITCHING OMMANDS
-
CLEAR PORT SECURITY INTRUSION
Table 15-2: Example output from show port-security interface
NOTE
cleared from the database.
To re-check the intrusion list on port1.0.2, use the following command:
awplus#
Table 15-3: Example output from show port-security intrusion
Related show port-security interface
commands
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
Command Version 5.5.1-0.1: port-security on LAGs added for SBx81CFC960, SBx908 GEN2,
changes x950, x930, x550, x530, x530L, x320, x230, x230L and x220 Series switches
C613-50644-01 Rev B

awplus#show port-security interface port1.0.2
Port Security configuration
------------------------------------------------------------
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Lock Status : LOCKED
Security Violation Count : 0
Last Violation Source Address : None
: Note that the port status is still locked while the history of port violation is
show port-security intrusion interface port1.0.2

awplus#show port-security intrusion interface port1.0.2
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
- no intrusions detected
520