Gvrp Commands; Introduction - Allied Telesis IE220 Series Manual

21

Introduction

Overview With Generic VLAN Registration Protocol (GVRP) enabled, the switch can exchange
VLAN configuration information with other GVRP enabled switches. VLANs can be
dynamically created and managed through trunk ports.
•
•
This chapter provides an alphabetical reference for commands used to configure
GVRP. For information about GVRP, including configuration, see the
Overview and Configuration
Command List •
•
•
•
•
•
•
•
•
•
•
•
C613-50644-01 Rev B

GVRP Commands

There is a limit of 400 VLANs supported by the AlliedWare Plus GVRP
implementation. VLANs may be numbered 1-4094, but a limit of 400 of these
VLANs are supported.
MSTP is not supported by the AlliedWare Plus GVRP implementation. GVRP
and MSTP are mutually exclusive. STP and RSTP are supported by GVRP.
"clear gvrp statistics" on page 794
"debug gvrp" on page 795
"gvrp (interface)" on page 797
"gvrp dynamic-vlan-creation" on page 798
"gvrp enable (global)" on page 799
"gvrp registration" on page 800
"gvrp timer" on page 801
"show debugging gvrp" on page 803
"show gvrp configuration" on page 804
"show gvrp machine" on page 805
"show gvrp statistics" on page 806
"show gvrp timer" on page 807
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Guide.
GVRP Feature
793