Allied Telesis IE220 Series Manual page 627

VLAN C
OMMANDS
SWITCHPORT VLAN TRANSLATION
Example To translate between internal VLAN100 and wire-VID 200 on port1.0.1, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
100
To add a translation entry to port1.0.1 for wire-VID 200 to add an outer-tag VID of
300 to packets received on the switch port, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
outer-vlan 300
To add a translation entry to port1.0.1 for wire-VID 200 to translate between it and
an internal VID of 100 and to add an outer-tag VID of 300, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
100 outer-vlan 300
To remove a translation entry from port1.0.1 for wire-VID 200, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove all translation entries from port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show interface switchport vlan translation
commands
switchport mode trunk
switchport vlan translation default drop
Command Version 5.4.8-0.2: added to SBx908 GEN2, x930 Series products
changes
Version 5.4.8-1.1: added to SBx8100 Series products
Version 5.4.9-0.1: added to x530 Series products
Version 5.4.9-1.1: added outer-vlan parameter for SBx908 GEN2, x950, x930, x510,
x510L, IE510-28GSX and IE300 Series switches.
Version 5.5.0-2.1: added outer-vlan parameter for x530 Series switches.
C613-50644-01 Rev B
configure terminal
interface port1.0.1
switchport vlan translation vlan 200 vlan
configure terminal
interface port1.0.1
switchport vlan translation vlan 200
configure terminal
interface port1.0.1
switchport vlan translation vlan 200 vlan
configure terminal
interface port1.0.1
no switchport vlan translation vlan 200
configure terminal
interface port1.0.1
no switchport vlan translation all
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
627