Udld Time Disable-Period - Allied Telesis IE220 Series Manual

U L D
NIDIRECTIONAL INK ETECTION
-
UDLD TIME DISABLE PERIOD

udld time disable-period

Overview Use this command to set the UDLD disable period on all interfaces. The disable
period is the time (in seconds) that a port is marked disabled before UDLD
attempts to recheck it.
Manually reset the UDLD status of a port using the
Use the no variant of this command to reset the disable period to infinite.
udld time disable-period <seconds>
Syntax
no udld time disable-period
Default The default time disable period is infinite.
Mode Global Configuration
Example To change the UDLD disable period to 60 sec on all interfaces, use the commands:
awplus#
awplus(config)#
To reset the disable period to infinite, use the commands:
awplus#
awplus(config)#
Related udld enable
commands
udld port
show udld
C613-50644-01 Rev B
(UDLD) C
OMMANDS
Parameter Description
30-86400 
<seconds>
Specify the disable period in seconds.
configure terminal
udld time disable-period 60
configure terminal
no udld time disable-period
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
udld reset command.
731