Udld Time Message-Interval - Allied Telesis IE220 Series Manual

U L D
NIDIRECTIONAL INK ETECTION
-
UDLD TIME MESSAGE INTERVAL

udld time message-interval

Overview Use this command to set the UDLD message send interval on all interfaces.
This is the time, in seconds, between UDLD probe messages.
Use the no variant of this command to reset the message send interval to 15
seconds.
udld time message-interval <seconds>
Syntax
no udld time message-interval
Default The default message send interval is 15 seconds.
Mode Global Configuration
Example To change UDLD message sending interval to 30 sec on all interfaces, use the
commands:
awplus#
awplus(config)#
To reset the message sending interval to 15 seconds, use the commands:
awplus#
awplus(config)#
Related udld enable
commands
udld port
show udld
C613-50644-01 Rev B
(UDLD) C
OMMANDS
Parameter Description
<seconds>
7-90
Specify the message send interval in seconds.
configure terminal
udld time message-interval 30
configure terminal
no udld time message-interval
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
732