Table of Contents
Advertisement
P
E
C
OWER OVER
THERNET
OMMANDS
-
SHOW POWER
INLINE
show power-inline
Overview
This command displays the Power over Ethernet (PoE) status for all ports.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax
show power-inline
Mode
User Exec and Privileged Exec
Example
To display the PoE status for all ports, use the following command:
awplus#
Output
Figure 20-2: Example output from show power-inline.
awplus#show power-inline
PoE Status:
Stack member 1
Nominal Power: 240W
Power Allocated: 30W
Power Requested: 30W
Actual Power Consumption: 3W
Operational Status: On
Power Usage Threshold: 80% (192W)
Detection of legacy devices is disabled
Power Source: PSU
High Availability Network Power: Disabled
Thermal State: Operational
Power management mode: Static
PoE Interface:
Interface/
Admin
Pair
port1.0.1/D
Enabled
port1.0.2/D
Enabled
port1.0.3/D
Enabled
port1.0.4/D
Enabled
...
Table 1: Parameters in the show power-inline command output
C613-50644-01 Rev B
show power-inline
Pri
Oper
Low
Powered
Low
Off
Low
Off
Low
Off
Parameter
Nominal Power
Power Allocated
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Power Device
(mW)
3432 n/a
0 n/a
0 n/a
0 n/a
Description
The nominal power available on the switch in watts (W).
The current power allocated in watts (W) that is available to
be drawn by any connected Powered Devices (PDs). This is
updated every 5 seconds.
"Getting Started
Guide.
Class Max
(mW)
4 30000 [C]
n/a
n/a
n/a
n/a
n/a
n/a
781
Advertisement
Table of Contents
