Platform Multicast-Ratelimit - Allied Telesis IE220 Series Manual

S C
WITCHING OMMANDS
-
PLATFORM MULTICAST RATELIMIT

platform multicast-ratelimit

Overview Use this command to set the maximum number of multicast packets to be
forwarded to the CPU (in packets per second). Setting the value to zero disables
rate limiting.
This command should be used with care. Increasing or removing the limit could
make the device less responsive under heavy multicast load.
Use the no variant of this command to return the limit to its default.
platform multicast-ratelimit <0-1000>
Syntax
no platform multicast-ratelimit
Default 10 packets per second (pps)
Mode Global Configuration
Usage notes If you find that the CPU load on your device from multicast traffic is higher than
desired, reducing this rate may reduce the CPU load.
If you need the device to process a large amount of multicast traffic, increasing this
rate may improve performance.
Example To set the rate to 30pps, use the commands:
awplus#
awplus(config)#
Command Version 5.4.8-1.1: default changed to 100pps on SBx908 GEN2, SBx8100, and x930
changes Series switches.
C613-50644-01 Rev B
configure terminal
platform multicast-ratelimit 30
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
542