Delta EB3000 Series User Manual page 69

Chapter 4 WiringEB3000
4-5 Remove the Cover before Wiring
Follow the steps below to remove the top cover before wiring the multi-function input and output
terminals.
NOTE: The drive figures shown below are for reference only. The actual drive may look different.
1. Press the snaps on both sides of the top cover.
2. Detach the top cover by rotating it with the direction as Figure 4-16 below shows.
3. Making the wiring after detaching the top cover.
4. After finishing the wiring, attach the top cover and make sure the upper hooks of top cover have
already plugged into the upper grooves of middle case.
5. Rotate the top cover in an opposite direction and attach until the snaps engage the grooves of
middle case with a click.
Step 1: Press the
snaps of top cover
Figure 4-15
Step 4: Attach the top cover
Step 2: Detach the top cover
Figure 4-18
Figure 4-16
Step 5: Make the snaps engaged
4-16
Step 3: Making the wiring
Figure 4-17
Figure 4-19