Delta EB3000 Series User Manual page 417

Chapter 11 Optional AccessoriesEB3000
11-7-2 Installation
This illustration uses Frame A as an example. Follow the steps below to install the EMC shield plate.
1. Loosen the two screws at the bottom of the drive. NOTE: Step 1 is only applicable for Frame A.
2. ○ Insert the EMC shield plate into the grooves at the bottom of the drive.
1
○ Then, fix the plate using the enclosed screws with the torque value recommended in the table
2
below.
Frame Screw
A M4 * P0.7 * L10
B M4 * P0.7 * L10
Qty. Recommended Torque
2 12–16 kg-cm / (10.42–13.89 lb-in.) / (1.18–1.57 N-m)
2 12–16 kg-cm / (10.42–13.89 lb-in.) / (1.18–1.57 N-m)
11-28