Table of Contents
Advertisement
Chapter 5 Operation InterfaceEB3000
1.
Parameter Setup
Press
to select.
Press
to select the
parameter group.
Once you select a parameter
group, press
that group.
5.
Copy Parameter
Press ENTER to go to 001–
004: content storage
For example: Setup source for the master frequency command.
to go into
Four groups of parameters are available to copy.
The steps are shown in the example below.
Example: parameter saved in the motor drive.
Example: parameter saved in the keypad.
In Parameter Group 00 Basic Parameters, use
Up/Down keys to select parameter 20: Auto Frequency
Command.
Press ENTER to go to this parameter's setting menu.
Use Up/Down keys to choose a setting.
For example: choose "2 Analog Input", and then press
ENTER.
After you press ENTER, END is displayed which
means the parameter setting is done.
NOTE: When parameter lock / password protection
function is enabled, it displays "Pr. lock" on the upper
right corner of the keypad. The parameter cannot be
written or is protected by the password under this
circumstances.
1. Go to "Copy Parameter"
2. Select the parameter group to copy and press ENTER
key.
1. Select 1: keypad VFD
2. Press ENTER key to go to "keypad VFD" screen.
Begin copying parameters until it is done.
After copying parameters is done, the keypad
automatically returns to this screen.
1. Go to Copy parameter
2. Select the parameter group to copy and press ENTER.
Press ENTER to go to "VFD keypad" screen.
Press Up / Down keys to select a symbol.
Press Left / Right keys to move the cursor to select a file
name.
5-10
Advertisement
Table of Contents
