Delta EB3000 Series User Manual page 274

Communication Detection
04-60
COM Transmission Fault Treatment

VF
Control Mode
Settings
 Determines the treatment if a transmission time-out error (such as disconnection) occurs during
communication.
04-61
Time-out Detection

VF
Control Mode
Settings
 Sets the communication time-out value.
04-62
Communication (RJ45) Fault Treatment

VF
Control Mode
Settings
 Determines the treatment if a transmission time-out error (such as disconnection) occurs during
communication.
04-63
Communication (RJ45) Time-out

VF
Control Mode
Settings
 Sets the communication time-out value
04-64
Communication (RJ45) Delay Time

VF
Control Mode
Settings
 If the host computer does not finish the transmitting/receiving process, you can use this
parameter to set the response delay time after the AC motor drive receives communication
command as shown in the following picture.
RS-485 BUS
PC or PLC command
SVC FOCPG
0: Warn and keep operation
1: Fault and ramp to stop
2: Reserved
3: No action and no display
SVC FOCPG
0.0–100.0 sec.
0.0: Disable
SVC FOCPG
0–3
0: Warn and keep operation
1: Fault and ramp to stop
2: Reserved
3: No action and no display
SVC FOCPG
0.0–100.0
SVC FOCPG
0.0–200.0
Handling time
of the AC drive
8-04-11
Chapter 8 Descriptions of Parameter SettingsEB3000
FOCPM Default: 3
FOCPM Default: 0.0
FOCPM Default: 3
FOCPM Default: 0.0
FOCPM
Default: 2.0
Response Delay Time
Response Message
of the AC Drive