Delta EB3000 Series User Manual page 114

File Copy Setting Fault Description
These faults occur when KPC-CC01 cannot perform the command after pressing the ENTER key in
the copy function.
LCD Display
Read only
(ERR1)
Write in error
(ERR2)
Drive operating
(ERR3)
Parameter locked
(ERR4)
Parameter
changing
(ERR5)
Fault code
(ERR6)
Warning code
(ERR7)
Fault Name Description
Parameter and file are
read-only
Fail to write parameter and
file
AC motor drive is in
operating status
AC motor drive parameter
is locked
AC motor drive parameter
is changing
Fault code is not cleared
Warning code is not
cleared
Chapter 5 Operation InterfaceEB3000
The parameter / file is read-only and
cannot be written to.
1. Verify the specification in the user
manual.
If this solution does not work, contact your
local authorized dealer for assistance.
An error occurred while writing to a
parameter / file.
1. Check for any problem on the Flash IC.
2. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your local authorized dealer for
assistance.
A setting cannot be changed while the
motor drive is in operation.
1. Verify that the drive is not in operation.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because a
parameter is locked.
1. Check if the parameter is locked. If it is
locked, unlock it and try to set the
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because a
parameter is being modified.
1. Check if the parameter is being
modified. If it is not being modified, try
to change that parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because an
error has occurred in the motor drive.
1. Check if any error occurred in the motor
drive. If there is no error, try to change
the setting again.
If this solution does not work, contact your
local authorized dealer for assistance.
A setting cannot be changed because of a
warning message given to the motor drive.
1. Check if there is a warning message
given to the motor drive.
If this solution does not work, contact your
local authorized dealer for assistance.
5-23
Corrective Actions