Delta EB3000 Series User Manual page 360

Cause
FRAM cannot be written
Abbreviated
ID No.
Fault Code
31 cF2
Action condition
Action time
Fault treatment parameter N/A
Reset method
Reset condition
Record
Cause
FRAM cannot be read
Abbreviated
ID No.
Fault Code
32 cd0
Action condition
Action time
Fault treatment parameter N/A
Reset method
Reset condition
Record
Cause
Hardware failure
Abbreviated
ID No.
Fault Code
33 cd1
Action condition
Action time
Fault treatment parameter N/A
Reset method
Reset condition
Record
Cause
Hardware failure
1. Press RESET key. If cF1 still exists, return to the factory for repair.
2. Reset the parameter to the default setting. If cF1 still exists, return to the factory for
repair.
3. Cycle the power. If cF1 still exists, return to the factory for repair.
Display on
Fault Name
KPED-LE02
FRAM read error
Action and Reset
Firmware internal detection read error
Immediately acts when the drive detects the fault
Manual reset
Resets immediately
Yes
1. Press RESET key. If cF2 still exists, return to the factory for repair.
2. Cycle the power. If cF2 still exists, return to the factory for repair.
Display on
Fault Name
KPED-LE02
Current detection error
Action and Reset
Output current is larger than 225% of the drive's rated current while initializing
Immediately acts
Cycle the power
N/A
Yes
Cycle the power.
If cd0 still occurs, return to the factory for repair.
Display on
Fault Name
KPED-LE02
U-phase error
Action and Reset
U-phase current level deviation is larger than 10% of the drive's rated current while
initializing
Immediately act
Cycle the power
N/A
Yes
Cycle the power.
If cd1 still occurs, return to the factory for repair.
Chapter 9 Warning and Fault CodesEB3000
Corrective Actions
FRAM cannot be read
Corrective Actions
Drive current detection error when powered-
on
Corrective Actions
Drive's U-phase current detection error when
powered-on
Corrective Actions
9-29
Description
Description
Description
<Go to List of Fault Codes>