Delta EB3000 Series User Manual page 376

Abbreviated
ID No.
Fault Code
93 CndL
Action condition
Action time
Fault treatment parameter Stops output immediately, and coasts to stop.
Reset method
Reset condition
Record
Cause
CANLift communication
time-out
Abbreviated
ID No.
Fault Code
95 CnLF
Action condition
Action time
Fault treatment parameter Stops output immediately, and coasts to stop.
Reset method
Reset condition
Record
Cause
CANLift PDO error
Abbreviated
ID No.
Fault Code
96 Stod
Action condition
Action time
Fault treatment parameter N/A
Reset method
Reset condition
Record
Cause
STO function is active
before running
Abbreviated
ID No.
Fault Code
97 Stor
Action condition
Action time
Fault treatment parameter N/A
Reset method
Reset condition
Record
Cause
DC braking time is too long Time for STO circuit deactivation must be longer than DC braking time
Display on
Fault Name
KPED-LE02
CANLift disconnection CANLift disconnection
Action and Reset
CANLift is disconnected
Based on the communication time of elevator controller
Reset signal is received
Resets immediately
Yes
Check CAN Bus wiring and time setting for CANLift heartbeat of elevator controller
Display on
Fault Name
KPED-LE02
CANLift error
Action and Reset
CANLift PDO error
Immediately act
Reset signal is received
Resets immediately
Yes
Check PDOs sent by elevator controller, including check if target speed is larger than
maximum elevator speed (Pr.00-40), if target position is within limit range (Pr.05-16 to
Pr.05-15), and if target unit is set correctly (Pr.05-17 and Pr.05-18).
Display on
Fault Name
KPED-LE02
STO disconnection
Action and Reset
STO circuit is OFF while drive outputs
20 ms
Manual reset
N/A
Yes
Make sure STO function is non-active before sending a RUN command.
Display on
Fault Name
KPED-LE02
STO at running
Action and Reset
STO circuit is OFF while drive outputs
10 ms
Manual reset
N/A
Yes
Chapter 9 Warning and Fault CodesEB3000
Corrective Actions
CANLift PDO error
Corrective Actions
STO circuit is OFF during running
Corrective Actions
STO circuit is OFF when frequency outputs
Corrective Actions
9-45
Description
Description
Description
Description
<Go to List of Fault Codes>