Delta EB3000 Series User Manual page 480

Function Modbus
Name Address (Function Code)
Frequency
2001H
command
Fault /
control
2002H
command
source
Status monitor read only (21xx): communication station address is Pr.09-00 setting value
Function Name
Fault status
Attribute
bit11–8
bit12
bit13–15 Reserved
R (03H) / Frequency command (XXX.XX Hz). There are two decimal places for
W (06H, 10H) general-purpose drives.
bit0
R (03H) /
W (06H, 10H)
bit1
bit15–2 Reserved
Attribute
Modbus
(Function
Address
Code)
2100H R (03H)
Appendix B. Modbus ProtocolEB3000
Description
01B: 2nd accel. / decel.
10B: 3rd accel. / decel.
11B: 4th accel. / decel.
0000B: zero step speed
0001B: 1st step speed
0010B: 2nd step speed
0011B: 3rd step speed
0100B: 4th step speed
0101B: 5th step speed
0110B: 6th step speed
0111B: 7th step speed
1000B: 8th step speed
1001B: 9th step speed
1010B: 10th step speed
1011B: 11th step speed
1100B: 12th step speed
1101B: 13th step speed
1110B: 14th step speed
1111B: 15th step speed
1: Enable bit06–11 function
1: External Fault (E.F.) ON
1: Reset
bit7–0: Fault code
bit15–8: Warning code
B-11
is set to 1.
2. Obtain the current running
speed by reading 2107h.
Used to trigger an external
fault to the drive to make it
stop running. Drive's stop
method can be set through
drive parameters.
Used to clear the fault status
Description