Delta EB3000 Series User Manual page 209

Chapter 8 Descriptions of Parameter SettingsEB3000
Settings Functions
The first, second
8 acceleration or
deceleration time
The third, fourth
9 acceleration or
deceleration time
10 EF Input
11: Reserved
12 Stop output
13–14: Reserved
AUI1 operation speed
15
command
16: Reserved
AUI2 operation speed
17
command
18 Emergency Stop
19–23: Reserved
24 FWD JOG command
25 REV JOG command
26: Reserved
27 ASR1/ASR2 selection
Emergency stop (EF1)
28
(Motor coasts to stop)
29–30: Reserved
31 High torque bias
You can select the motor drive's acceleration and deceleration time
through the terminals; there are four acceleration and deceleration
speeds in total.
Bit 0 Bit 1
MI = 9 MI = 8
First accel. /decel. time
When output frequency is less than
0 0 Pr.00-81 (Switch Frequency between
First/Fourth Accel./Decel.), it outputs
the fourth accel./decel. time.
0 1 Second accel./decel. time
1 0 Third accel./decel. time
1 1 Fourth accel./decel. time
If the drive receives STOP command, it decelerates to stop with Pr.00-82.
External fault input terminal, and decelerates according to Pr.02-16
(records EF fault).
When enabled, the motor drive output stops immediately and the motor
coasts. When disabled, the motor drive accelerates to the frequency
setting.
When the operation speed command source is AUI1 and AUI2, and two
or more terminals are ON, the priority is AUI1 > AUI2.
When enabled, the frequency source is AUI1.
When enabled, it forces the frequency source to AUI2.
When enabled, the motor drive ramps to stop according to Pr.02-16.
When enabled, the motor drive executes the forward Jog command.
When enabled, the motor drive executes the reverse Jog command.
ON: Speed is adjusted according to ASR 2.
OFF: Speed is adjusted according to ASR 1.
ON: The motor drive executes emergency stop and records the fault
code.
When Pr.02-41 is set to 3:
Set the high torque bias in Pr.02-43.
Set the middle torque bias in Pr.02-44.
Set the low torque bias in Pr.02-45.
8-01-4
Descriptions
Descriptions