Delta EB3000 Series User Manual page 109

Chapter 5 Operation InterfaceEB3000
Other displays
When a fault occurs, the screen displays shows the fault or warning:
1. Press STOP / RESET key to reset the fault code. If there is no response, contact your local distributor or
return the unit to the factory. To view the fault DC bus voltage, output current and output voltage, press MENU
and then choose 6: Fault Record.
2. After resetting, if the screen returns to the main screen and shows no fault after you press ESC, the fault is
cleared.
3. When the fault or warning message appears, the LED backlight blinks until you clear the fault or the warning.
Optional accessory: RJ45 Extension Lead for Digital Keypad
Part No.
CBC-K3FT
CBC-K5FT
CBC-K7FT
CBC-K10FT
CBC-K16FT
NOTE: When you need to buy communication cables, buy non-shielded, 24 AWG, four-wire twisted pair, 100
ohms communication cables.
Before using the user-defined start-up screen and user-defined main
screen, you must preset the start-up screen and the main screen as user-
defined. If you do not download the user-defined screen to the KPC-CC01,
the start-up screen and the main screen are blank.
RJ45 extension lead, 3 feet (approximately 0.9 m)
RJ45 extension lead, 5 feet (approximately 1.5 m)
RJ45 extension lead, 7 feet (approximately 2.1 m)
RJ45 extension lead, 10 feet (approximately 3 m)
RJ45 extension lead, 16 feet (approximately 4.9 m)
5-18
Start to upload parameters to VFDSoft
Uploading parameter is completed
Description