Delta EB3000 Series User Manual page 338

Abbreviated
ID No.
Warning Code
7 SE1
Action condition
Action time
Warning treatment
parameter
Reset method
Reset condition
Record
Cause
Communication connection
error
Built-in keyboard panel
error
Control board error
Abbreviated
ID No.
Warning Code
8 SE2
Action condition
Action time
Warning treatment
parameter
Reset method
Reset condition
Record
Cause
Add new parameters to the
old firmware version.
Malfunction caused by
interference
Display on
Warning Name
KPED-LE02
Save error 1
Action and Reset
"SE1" warning occurs when the built-in keyboard panel does not transmit the COPY
command to the drive, or does not transmit any data to the drive again in five seconds
at the time you copy the parameters to the drive.
5 seconds
N/A
Manual reset
Resets immediately
No
SE1: The causes of error are mostly communication problems between the built-in
keyboard panel and control board. Potential causes include communication signal
interference and the unacceptable communication command to the Slave. It is
suggested to check the communication quality and remove the error causes first.
Check if the error occurs randomly, or only occurs when copying certain parameters
(the error displays on the upper right corner of the copy page). If you cannot clear the
error, contact Delta.
Display on
Warning Name
KPED-LE02
Save error 2
Action and Reset
"SE2" warning occurs when writing the parameters incorrectly at the time you copy
parameters to the drive. For example, you copy the new firmware version with added
parameters to the drive with old firmware version.
N/A
N/A
Manual reset
Resets immediately
No
SE2: In this stage, the copied data has been transmitted to the Slave.
The Slave compares and processes the copied data, and then saves the data to the
Data ROM. During the process, the data error (should be attribution error) may occur,
or the data cannot be saved to EEPROM. At this time, the warning occurs.
It is suggested to check the status of Data ROM and remove the error causes first.
If you cannot clear the error, contact Delta.
Verify the wiring and grounding of the main circuit, control circuit and the encoder for
effective anti-interference performance.
Chapter 9 Warning and Fault CodesEB3000
Built-in keyboard panel copy error 1: copy
time-out
Corrective Actions
Built-in keyboard panel copy error 2:
parameter writing error
Corrective Actions
9-7
Description
Description
<Go to List of Warning Codes>