Delta EB3000 Series User Manual page 37

Chapter 3 Option CardsEB3000
4. Line driver output encoder application: Each set of input current is 5–15 mA. If input voltage
uses 12V power, connect the encoder power externally. See the PG wiring Figure 3-11
below.
NOTE:
1. Verify that the SW1 is set to the correct output voltage before powering ON.
2. Keep the motor drive wiring away from any high voltage lines to avoid interference.
EMEB-PGAB-1
ABZ/UVW
4.7kohm
ABZ/UVW
Figure 3-10
EMEB-PGAB-1
VP
ABZ/UVW
4.7kohm
ABZ/UVW
0V
Figure 3-11
Line Driver Encoder
VP
0V
Line Driver Encoder
VCC
ABZ/UVW
ABZ/UVW
GND
3-16
VCC
ABZ/UVW
ABZ/UVW
GND
External
power
(5–12V)