Delta EB3000 Series User Manual page 422

11-8-2 Installation
This illustration uses Frame A as an example. Follow the steps below to install the conduit box.
1. Loosen the two screws at the bottom of the drive. NOTE: Step 1 is only applicable for Frame A.
2. Hook the fold (each on both sides) of the conduit box base to the middle case of the drive, and
make sure its underneath has been inserted into the grooves at the bottom of the drive. Then,
rotate the conduit box in a direction as the narrow shows in the figure.
Chapter 11 Optional AccessoriesEB3000
11-33