Delta EB3000 Series User Manual page 241

Chapter 8 Descriptions of Parameter SettingsEB3000
 This parameter is used with the settings 35–38 in Pr.01-10–Pr.01-15 (multi-function output). The
fault output selections 1–4 correspond to Bit 0–3.
 This parameter provides two setting methods for the fault output.
0: Set according to the settings in Pr.02-71–Pr.02-74.
1: Set according to the binary setting. Refer to the following example for details.
Example:
Assume that:
Pr.01-10 (Multi-function output Relay 1) is set to 35 Fault output option 1 (Pr.02-71).
Pr.01-11 (Multi-function output Relay 2) is set to 36 Fault output option 2 (Pr.02-72).
Pr.01-12 (Multi-function output Relay 3) is set to 37 Fault output option 3 (Pr.02-73).
Pr.01-13 (Multi-function output Relay 4) is set to 38 Fault output option 4 (Pr.02-74).
Also assume that external fault outputs with the following signal: RLY1 = 1, RLY2 = 1, RLY3 = 0
and RLY4 = 1. The corresponding Bit 3–0 is 1011.
Bit 3 Bit 2
-
0
0
0
0
0
0
0
1
Bit 1 Bit 0
- - -
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
0 0 0
Fault Code
0: No fault record
1: Over-current during acceleration (ocA)
2: Over-current during deceleration (ocd)
3: Over-current during constant speed (ocn)
4: Ground fault (GFF)
5: IGBT short-circuit (occ)
6: Over-current at stop (ocS)
7: Over-voltage during acceleration (ovA)
8: Over-voltage during deceleration (ovd)
9: Over-voltage during constant speed (ovn)
10: Over-voltage at stop (ovS)
11: Low voltage during acceleration (LvA)
12: Low voltage during deceleration (Lvd)
13: Low voltage during constant speed (Lvn)
14: Low voltage at stop (LvS)
15: Phase loss (PHL)
16: IGBT overheating fault (oH1)
18: IGBT temperature detection failure (tH1o)
21: Overload (oL)
22: Electronic thermal relay 1 protection (EoL1)
24: Motor over-heating PTC (oH3)
26: Over-torque 1 (ot1)
30: FRAM writing error (cF1)
31: FRAM read error (cF2)
32: Current detection error (cd0)
33: U-phase error (cd1)
34: V-phase error (cd2)
8-02-18