MINOLTA-QMS magicolor 6100 Series Service Manual page 48

Page 3-16
4. Lift up the printer with assistance,
and mount it on the LFU.
A. Slowly lower the printer so its
bottom hole meets the adjuster
pin of the LFU.
B. After placing the printer on the
LFU, confirm that all parts meet
properly.
5. Couple the printer with the LFU.
A. The metal coupler is fixed to
the rear left area by a thumb-
screw (see Fig. 3-27).
B. Loosen the thumbscrew, and
hook the leading edge of metal
coupler onto the engine base
(see Fig. 3-27).
C. Tighten the thumbscrew to
secure the metal coupler.
D. Look into the entrance of the
cassette slot for the tray latch
at the right front side of the
LFU. The tray latch can be
pivoted on its set screw.
E. Pivot the tray latch so that it is
hooked to the engine base.
Metal Coupler
Claw
Claw
Tray Latch
Fig. 3-29
magicolor 6100 Series Service Manual
Printer
Engine
LFU
Fig. 3-26
Fig. 3-27
Fig. 3-28