MINOLTA-QMS magicolor 6100 Series Service Manual page 308

7.9.2
Page 7-108
Paper Size Sensor (SL3-PS -A57 P.W.B. Assembly)
7.9.2.1 Tool
#1 Phillips Screwdriver
7.9.2.2 Disassembly Procedures
(see Fig. 7-109)
1. Open the LFU back door.
2. Remove the LFU paper guide by removing four set screws (ST3x6).
3. Remove the paper size sensor from the paper feeder base by remov-
ing two set screws (ST3x6).
4. Disconnect the paper size sensor connector.
5. Remove the paper size sensor.
7.9.2.3 Assembly Procedures
1. Reassemble in reverse order of disassembly.
Paper Size Sensor
Fig. 7-109
magicolor 6100 Series Service Manual