MINOLTA-QMS magicolor 6100 Series Service Manual page 156

5.3.9
Page 5-26
Replacement of the Transfer Drum
5.3.9.1 Replacement Criteria
Since the transfer drum is defined as a periodic replacement parts in Table
5-4, it should be replaced when a print quality failure occurs due to failed
transfer drum. The warning code "TD" appears in the operator panel.
5.3.9.2 Replacement Procedures
1. Whenever the error occurs, confirm that the cause is the same as out-
lined in section 8.5 "Imaging Failures".
1. If the failure is caused by the transfer drum, replace it according to
the replacement procedures set out in the section 7.6.3.
1. Upon Completion of the warming-up process, clear the code "TD" by
Service Mode CLEAR CARE mode.
This procedure is a periodic replacement task, but it can-
not be done by the customer. This should be done by a
service technician upon request of the customer or at
periodic maintenance.
After the replacement, confirm the improvement of print
quality by printing a test print.
CAUTION
magicolor 6100 Series Service Manual