MINOLTA-QMS magicolor 6100 Series Service Manual page 147

5.3.3
magicolor 6100 Series Service Manual
Replacement of the Fuser
(see Fig. 5-17 through Fig. 5-19)
5.3.3.1 Criterion of Replacement
The fuser should be replaced with a new unit according to the periodic
maintenance cycle set out in the Table 5-4. When it is time to replace the
fuser, the warning code "REPLACE FUSER" appears on the LCD of the
operator panel.
5.3.3.2 Purpose of Replacement
To prevent the print quality from declining due to the deterioration of
fuser's roller.
5.3.3.3 Precaution
(see Fig. 5-16)
Allow the fuser to cool before performing this procedure.
5.3.3.4 Tools and Supplies:
1. Fuser
1. Lint-free cotton cloth (2 ~ 3)
5.3.3.5 Procedures
5.3.3.5.1
1.
2.
3.
Fig. 5-16
WARNING
Fuser Removal Procedures:
After turning off the power switch, unplug the power cord
from the outlet.
Open the paper exit unit.
Remove the two thumbscrews from the fuser (see Fig. 5-17).
Thumb Screws
Fig. 5-17
Page 5-17