MINOLTA-QMS magicolor 6100 Series Service Manual page 310

Page 7-110
8. Disconnect the clutch connector clutch.
9. Remove the LFU top cover.
a. Remove the LFU harness clamp by removing one set screw
(ST4x8).
b. Remove seven set screws (ST4x8).
c. Check the five boss pin locations for reassembly.
10. Remove the stopper washer of the paper feeder clutch, and pull out
the paper feeder clutch from the shaft.
11. Remove the paper transportation clutch.
a. Remove the fixing washer from the inside of bearing.
b. Slide the shaft from the top cover.
c. Remove the paper transportation part (rubber roller) from the
bearing.
d. Remove the fixing washer from the paper transportation clutch,
and pull the paper transportation clutch from the shaft.
7.9.3.3 Assembly Procedures
1. Install the paper transportation clutch.
2. Install the paper feeder clutch.
3. Reassemble in reverse order of disassembly.
Fig. 7-111
Paper Feeder Clutch
magicolor 6100 Series Service Manual