MINOLTA-QMS magicolor 6100 Series Service Manual page 256

7.5.5
Paper Exit
Frame Assembly
Page 7-56
Paper Sensor (Paper Exit Sensor PT2)
7.5.5.1 Tool
#2 Phillips Screwdriver
7.5.5.2 Disassembly Procedures
(see Fig. 7-50)
1. Open the paper exit cover.
2. Remove the paper exit unit (see section 7.6.6).
3. Remove the paper exit cover (see section 7.1.6).
4. Remove two set screws (ST3x6) from the sensor base.
5. Remove the sensor base from paper exit frame.
6. Disconnect the harness connector from the paper exit sensor (PT2).
7. Remove the paper sensor from the sensor base.
Sensor
Base
Sensor
PT2
PT2 Lever
Paper Sensor PT2
7.5.5.3 Assembly Procedures
1. Install a new paper sensor (PT2) onto the paper guide.
2. Connect the harness connector to the paper sensor.
3. Reassemble in reverse order of disassembly.
Release Arm
Fig. 7-50
Paper Exit Cover
Assembly
magicolor 6100 Series Service Manual