MINOLTA-QMS magicolor 6100 Series Service Manual page 191

Step
Select EACH IMAGE SET.
1
The LCD changes as shown in (a) ---> (b)
Select the desired color for EACH IMAGE SET.
2
The LCD changes as shown in (b) ---> (c)
Use the Scroll key to designate or change the desired digits.
Use the Select key to select a digit.
3 After selecting the values to be set, use the Scroll key to
move the cursor to SET, and then press the Select key to
select the value.
The LCD changes as shown in (c) ---> (d)
Press the Media key to exit from the EACH IMAGE SET
mode.
4
The LCD changes as shown in (d) ---> (e)
magicolor 6100 Series Service Manual
6.4.3.8.6.9
Table 6-26: Each Image Reset Procedure
Description of Procedure
Each Image Reset
Note: These are factory settings and should not
be changed.
This mode resets the number of total planes/
images printed for each color in NVRAM
when executing NVRAM INITIAL or replac-
ing the MCTL PWB.
Message in LCD
39 FACTORY MODE
(a)
48 IMAGE OF
(b)
48 IMAGE OF C
(c)
48 IMAGE OF
(d)
39 FACTORY MODE
(e)
EACH IMAGE SET
Y / M / C / K
005432 P SET
Y / M / C / K
DP CHECK
Page 6-35