MINOLTA-QMS magicolor 6100 Series Service Manual page 292

Lower-rear
Cover
Fig. 7-86
Page 7-92
7.8.1.9 Reverse Paper Guide Unit
7.8.1.9.1
7.8.1.9.2
Reverse Paper
Guide
Paper
Guide Bottom
7.8.1.9.3
Tool
#1 Phillips Screwdriver
Disassembly Procedures
(see Fig. 7-86 and Fig. 7-87)
1. Remove the lower-right and lower-left covers (see sec-
tion 7.8.1.1 and section 7.8.1.2).
2. Remove the bottom paper guide (section 7.8.1.11).
3. Remove the four set screws (ST3x6) from the support
shaft ends.
4. Remove lower-rear cover (section 7.8.1.7).
5. Remove the support shaft from the frame.
6. Remove the retaining band from the reverse paper guide
unit.
7. Remove the reverse paper guide unit from the frame.
8. Remove the harness connected with the connector CN2
of Relay P.W.B.
Reverse Input
Paper Guide
Assembly Procedures
1. Reassemble in reverse order of disassembly.
Reverse Paper
Guide
Fig. 7-87
magicolor 6100 Series Service Manual