MINOLTA-QMS magicolor 6100 Series Service Manual page 240

7.3.4
Page 7-40
Developer Gear Unit
7.3.4.1 Tools
Phillips Screwdrivers #1 and #2
Small Screwdriver
7.3.4.2 Disassembly Procedures
(see Fig. 7-34)
1. Remove the toner cartridge.
2. Remove the waste toner bottle.
3. Remove the top cover (see section 7.1.5).
4. Remove one screw (ST3x6) from the back cover (RF); remove the
back cover (RF).
5. Remove two screws [one set screw (ST3x6), and one screw (ST4x6)]
from the front stay (R) RF.
6. Remove one set screw (ST3x6) from the waste toner bottle holder.
7. Remove the waste toner bottle holder.
8. Disconnect the connectors between the developer motor and the
IOD2 where each clutch is connected.
Note: When removing the developer gear, special spacers on the toner
shafts may fall out.
9. Remove three set screws (ST3x6) from the developer gear unit and
remove one set screw (ST3x6) from the MD stopper.
10. Remove the developer gear unit from the frame.
7.3.4.3 Assembly Procedures
1. Install the clutches and cam clutches to the developer gear unit.
2. Reassemble in reverse order of disassembly.
magicolor 6100 Series Service Manual