MINOLTA-QMS magicolor 6100 Series Service Manual page 277

7.6.8
magicolor 6100 Series Service Manual
Waste Toner Auger D (Stay 'A' Assembly)
7.6.8.1 Tool
#2 Phillips Screwdriver
Do not touch or scratch the transfer drum. Do not damage
the mylar seal of the waste toner auger D.
7.6.8.2 Disassembly Procedures
(see Fig. 7-69)
1. Open the front door.
2. Open the top door.
3. Remove the belt cartridge.
4. Remove the toner cartridges.
5. Remove the drum cleaner.
6. Remove the left-upper side cover (see section 7.1.1).
7. Remove the top cover (see section 7.1.5).
8. Remove the set screw (ST4x6) of stay 'A'.
9. Pull up the stay 'A' assembly along the guide.
7.6.8.3 Assembly Procedures
1. Reassemble in reverse order of disassembly.
CAUTION:
Fig. 7-69
Stay 'A'
Assembly
Page 7-77