MINOLTA-QMS magicolor 6100 Series Service Manual page 337

16-4
16
Confirmation for installation of cleaning roller.
Is the applicable cleaning roller installed properly ?
Does the sensor lever operate normally ?
Confirm that the cleaning roller is installed.
Is the message "16 ALIGN FUSER ROLLER" cleared ?
Confirmation of cleaning roller sensor.
Is the connector of sensor side connected ?
Is the connector DCN14 of IOD1 connected properly ?
Confirm the operation after connecting the connector of sensor side.
Is the message "16 ALIGN FUSER ROLLER" cleared ?
No
Is the message "16 ALIGN FUSER ROLLER" cleared ?
magicolor 6100 Series Service Manual
ALIGN FUSER CL ROLLER
Yes
Yes
No
Yes
Yes
No
Replace the IOD1 P.W.B.
Yes
Complete
No
Install the cleaning roller ?
No
Check the sensor lever.
Yes
No
Connect the connector.
No
Connect the connector.
Yes
Fig. 8-16
Page 8-23