MINOLTA-QMS magicolor 6100 Series Service Manual page 298

7.8.4
Motor (1)
Fig. 7-97
Page 7-98
Replacement of Motors
7.8.4.1 Motor (1)
7.8.4.1.1
7.8.4.1.2
7.8.4.1.3
Tool
#1 Phillips Screwdriver
Disassembly Procedures
(see Fig. 7-97, Fig. 7-98 and Fig. 7-99)
1. Remove the bottom paper guide (see section 7.8.1.111)
and the reverse paper guide unit (see section 7.8.1.9).
2. Remove the motor harness connector CN5 from the
Relay P.W.B.
3. Remove the harness cover, then remove the harness from
the clamp.
4. Remove the protective cover.
5. Remove the belt from the motor shaft.
6. Remove two set screws (ST3x6) from the motor (1).
7. Remove the motor (1) from the frame.
Motor (1)
Assembly Procedures
1. Reassemble in reverse order of disassembly.
Fig. 7-98
magicolor 6100 Series Service Manual