MINOLTA-QMS magicolor 6100 Series Service Manual page 244

7.3.6
Exhaust Side
Fig. 7-36
Page 7-44
Controller Fan (CTFAN)
7.3.6.1 Tools
#1 Phillips Screwdriver
7.3.6.2 Disassembly Procedures
(see Fig. 7-36 and Fig. 7-37)
1. Remove the left-upper side cover (see section 7.1.1).
2. Remove the left side cover (see section 7.1.3).
3. Remove the top cover (see section 7.1.5).
4. Remove the upper shield cover by removing 4 screws (ST3x6).
5. Remove one set screw (ST3x6) from the control fan case.
6. Disconnect the harness connector (IOD1 CN) from the controller fan.
7. Open the fan case by unhooking one latch, and remove the fan motor.
Controller Fan
Ozone Filter PS
7.3.6.3 Assembly Procedures
1. Install the fan motor into the fan case.
2. Reassemble in reverse order of disassembly.
Fan Case
Interlock Switch
Fig. 7-37
magicolor 6100 Series Service Manual
Fan Motor