7.5.13 Toner Sensor Assemblies (TPD and TTR)
Page 7-64
7.5.13.1 Tools
Phillips Screwdrivers #1 and #2
7.5.13.2 Disassembly Procedures
(see Fig. 7-58)
7.5.13.2.1 TPD
7.5.13.2.2 TTR
1. Remove the right side cover (see section 7.1.2).
2. Remove the developer drive unit (see section 7.3.3 and
see section 7.3.4).
3. Remove two set screws (ST3x6) from the toner sensor
P.W.B.
4. Disconnect the connector from the TPD toner sensor
P.W.B.
1. Remove the left side cover (see section 7.1.3).
2. Remove the high voltage power supply (HVPS) (see sec-
tion 7.2.6).
3. Remove the low voltage power supply (LVPS) (see sec-
tion 7.2.5).
4. Remove three set screws (ST3x6) of toner sensor P.W.B.
5. Disconnect the connector from the TTR toner sensor
P.W.B.
6. Remove the toner sensor P.W.B.
magicolor 6100 Series Service Manual