7.5.4
magicolor 6100 Series Service Manual
Paper Sensor (Paper Feeding Sensor PT1)
7.5.4.1
Tool
#1 Phillips Screwdriver
7.5.4.2
Disassembly Procedures
(see Fig. 7-49)
1. Remove the transfer unit (see section 7.6.1).
2. Remove the upper-left paper guide assembly by removing two set
screws (ST3x6).
3. Unlock the paper feeding sensor from the rear side of the hole
through which the upper-left paper guide has been removed.
4. Disconnect all the connectors from the paper feeding sensor.
5. Remove the paper feeding sensor from the feeder stay.
Transfer Unit Paper Sensor
Upper Left
Paper Guide
7.5.4.3
Assembly Procedures
1. Install a new paper feeding sensor to the feeder stay.
2. Connect the harness connectors to the paper feeding sensor.
3. Reassemble in reverse order of disassembly.
(PT1)
Fig. 7-49
Page 7-55