Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for MINOLTA-QMS Magicolor 2 Desklaser
Summary of Contents for MINOLTA-QMS Magicolor 2 Desklaser
- Page 1 2+ and magicolor 2 DeskLaser (Duplex Model) Repacking Instructions ® ® 1760268-001B...
-
Page 2: Copyright Notice
Trademarks The following are trademarks or registered trademarks of their respective owners. Other product names mentioned in this manual may also be trademarks or registered trademarks of their respective owners. Registered trademarks are registered in the United States Patent and Trademark Office; some trademarks may also be registered in other countries. - Page 3 Introduction If you need to relocate or ship your printer after it’s been installed, you must follow the procedures in this chapter to prevent damage to the printer and to keep your warranty valid. ! Caution: We cannot be held responsible for damage to your printer during shipment that results from the improper packaging of your printer.
-
Page 4: Remove Cables And Cassette(S)
Cassette(s) Remove Cables and Cassette(s) » Note: If you’re returning the printer for service, you don’t need to return the power cable, interface cables, or media cassette(s). Turn off the printer. Remove the power cable and all interface cables. - Page 5 Open the duplexer’s rear cover. With the printer’s front and top covers open, at the top of the fuser rotate the two green lock levers to release the oil bottle. Remove the oil bottle. Caution: Hold a sheet of paper under the oil bottle as you remove it, so no oil drips into the printer.
- Page 6 » Note: Don’t force the paper towels in, but make sure there are enough to fill the space. Close the green lock levers to secure the cleaning roller. magicolor 2+/ magicolor 2 DeskLaser Duplex Repacking...
- Page 7 They must be removed again before printing. Open the pressure-release levers (one at each end of the fuser) to separate the two rollers in the fuser. magicolor 2+/ magicolor 2 DeskLaser Duplex Repacking Prepare the Fuser Unit...
- Page 8 Close the pressure-release levers (one at each end of the fuser). When correctly positioned, the fuser roller shipping restraints fit snugly between the rollers. Close the printer’s top cover. 10 Close the duplexer’s rear cover. magicolor 2+/ magicolor 2 DeskLaser Duplex Repacking...
-
Page 9: Change The Waste Toner Pack
Change the Waste Toner Pack With the printer’s front cover open, remove the waste toner pack from the printer. Use the label on the side of the old waste toner pack to seal the opening, and then dispose of the pack in accordance with safety laws and regulations in your area. -
Page 10: Repack The Printer
Repack the Printer Repack the Printer Ensure that the fuser and fuser cleaner roller are in the printer. Place tape on the printer as shown in the illustrations. magicolor 2+/ magicolor 2 DeskLaser Duplex Repacking... - Page 11 With another person’s help, put the printer into the plastic bag, and place the printer into the base tray of the shipment carton. Pack the printer for shipment as shown in the illustration. magicolor 2+/ magicolor 2 DeskLaser Duplex Repacking...
- Page 12 Repack the Printer If you’re also shipping the power cord and any manuals with the printer, place them in the package at the rear of the printer, in the space between the D-center cover and the base packing box. »...
Need help?
Do you have a question about the Magicolor 2 Desklaser and is the answer not in the manual?
Questions and answers