MINOLTA-QMS magicolor 6100 Series Service Manual page 268

7.5.16 Toner Key Sensor TNK
Toner Key Sensor
Page 7-68
7.5.16.1 Tools
Phillips Screwdrivers #1 and #2
7.5.16.2 Disassembly Procedures
(see Fig. 7-61)
1. Remove the left-upper side cover (see section 7.1.1).
2. Remove the left side cover (see section 7.1.3).
3. Remove the shield case A assembly (see section 7.2.5.2[13]).
4. Remove the upper shield cover.
5. Disconnect the connector from DCN5 of IOD1.
6. Remove four set screws (ST3x6) from the toner key sensor.
7. Remove the toner key sensor.
7.5.16.3 Assembly Procedures
1. Install the new toner key sensor.
2. Reassemble in reverse order of disassembly.
Fig. 7-61
magicolor 6100 Series Service Manual