MINOLTA-QMS magicolor 6100 Series Service Manual page 270

7.6.2
Page 7-70
Registration Roller
7.6.2.1 Tools
#1 Phillips Screwdriver
Slotted Screwdriver #1
7.6.2.2 Disassembly Procedures
(see Fig. 7-63)
1. Open the transfer unit.
2. Remove the fixing washer of the roller at both ends.
3. Remove the gear from the shaft.
4. Remove the bearing from each end.
5. Remove the registration roller from the transfer unit frame.
7.6.2.3 Assembly Procedures
1. Install the new registration roller into the hole of the transfer unit
frame.
2. Install a bearing on each end.
3. Install the gear on the right side.
4. Install the fixing washer and the bearing.
Washer
Metal
Register roller
Metal
Fig. 7-63
Transfer Unit
Gear
magicolor 6100 Series Service Manual