MINOLTA-QMS magicolor 6100 Series Service Manual page 232

7.2.7
Left Side
Page 7-32
Erase Lamp
7.2.7.1 Tools
No special tools are required.
When handling any P.W.B. use ESD precautions.
7.2.7.2 Disassembly Procedures
(see Fig. 7-28)
1. Open the front and top doors.
2. Remove the toner cartridges and the belt cartridge.
3. Remove the erase lamp P.W.B. from the holder (3 locations) at the
front side.
4. Disconnect the connection of erase lamp harness connector.
5. Remove the erase lamp.
Back Side
7.2.7.3 Assembly Procedures
1. Install the erase lamp into the base frame.
2. Reassemble all items in reverse order of disassembly.
3. Connect the power supply cable.
4. Turn the power supply switch On.
5. Run a test print in Service Mode.
6. Confirm the print operation and print quality.
The erase lamp has directional characteristics. If it is
installed in the wrong direction, the transfer drum may be
damaged.
CAUTION:
Holder
Front Side
Connector
Erase Lamp
Fig. 7-28
CAUTION
(as viewed from the front side)
Fig. 7-29
magicolor 6100 Series Service Manual
Right Side