MINOLTA-QMS magicolor 6100 Series Service Manual page 178

Step
Select BD CHECK.
1
The LCD changes as shown in (a) ---> (b)
The Scanner motor scans the laser beam as it is rotating.
If the scanning position of the laser beam is normal,
"GOOD" is displayed in the LCD, otherwise, "FAIL" is
displayed.
2 The LCD changes as shown in (b) or (c)
Scanner motor automatically halts to rotate 60 seconds
after initial rotation.
The LCD changes as shown in (d)
Press the Media key to stop the BD CHECK mode.
3
The LCD changes as shown in (b) ---> (d)
Page 6-22
6.4.3.8.2 BD Check
The laser beam position and laser power can be confirmed.
Table 6-13: BD Check Procedures
Description of Procedure Message in LCD
39 FACTORY MODE
(a)
BD CHECK
41 BD CHECK
(b)
GOOD
41 BD CHECK
(c)
FAIL
39 FACTORY MODE
(d)
DP CHECK
magicolor 6100 Series Service Manual