Table of Contents
Advertisement
7.9.3
magicolor 6100 Series Service Manual
Paper Feeder Clutch (PKCLL) / Paper Transportation Clutch (DPKCL)
7.9.3.1
Tools
Phillips Screwdrivers #1 and #2
7.9.3.2
Disassembly Procedures
(see Fig. 7-110 and Fig. 7-111).
1. Remove the LFU from the printer.
2. Remove the pawl on the right side cover, unhook the hook at LFU
side, and then remove the right side cover.
3. Remove the LFU back door.
4. Remove the LFU paper guides by removing four set screws (ST3x6).
5. Remove the paper guide assembly by removing one set screw
(ST3x6).
6. Remove the left base cover.
a. Remove the anchor (foot).
b. Remove the rubber foot (1 pc.).
c. Remove two set screws (ST4x10).
d. Lift the left base cover straight up so that it comes out of the
adjuster base pin smoothly, and then remove the left base cover.
7. Remove the right base cover.
a. Remove the rubber foot (back side 1 pc.) by removing one set
screw (ST4x10 (1 pc.).
b. Remove two set screws (TS4x10).
c. Lift the right base cover straight up so that it comes out of the
adjuster base pin smoothly, and then remove the right base cover.
Fig. 7-110
Paper Feeder Clutch
Page 7-109
Advertisement
Table of Contents
Troubleshooting
