MINOLTA-QMS magicolor 6100 Series Service Manual page 336

16-3
16 ALIGN BELT CG
Confirmation for installation of belt cartridge.
No
Is the applicable belt cartridge installed properly ? Install the belt cartridge.
Yes
Yes
Is the OPC belt's mark smeared with toner ?
¡
Clean the smeared mark ¡ .
No
Confirm that the belt cartridge is installed properly.
Yes
Is the message "16 ALIGN BELT CG" cleared ?
No
Check the main motor system.
Yes
Is the main motor rotated ?
No
No
Is the connector ECN12 of IOD2 connected with the connector of main motor ?
Connect the connector.
Yes
Replace the main motor.
No
.Is the message "16 ALIGN BELT CG" cleared ?
Yes
Complete
Fig. 8-15
Page 8-22 magicolor 6100 Series Service Manual