Table of Contents
Advertisement
7.5.10 Drum Encoder Sensor (EN)
Drum Encoder
Sensor EN
Sensor Holder
magicolor 6100 Series Service Manual
7.5.10.1 Tools
Phillips Screwdrivers #1 and #2
7.5.10.2 Disassembly Procedures
(see Fig. 7-55)
1. Remove the toner cartridges (see section 3.3.3).
2. Remove the belt cartridge (see section 3.3.2).
3. Remove the drum cleaner (see section 7.1.12).
4. Remove the fuser (see section 7.7).
5. Remove the left side cover (see section 7.1.3).
6. Remove the top cover (see section 7.1.5).
7. Remove the transfer drum (see section 7.6.3).
8. Remove the high voltage power supply (see section 7.2.6).
9. Remove the sensor holder assembly from the frame (L).
10. Disconnect the connectors connected with the encoder sensor.
11. Remove the encoder sensor from the sensor holder.
Transfer Drum
7.5.10.3 Assembly Procedures
1. Install a new drum encoder sensor onto the sensor holder.
2. Reassemble in reverse order of disassembly.
Fig. 7-55
Paper Exit Frame Ass'y
Page 7-61
Advertisement
Table of Contents
Troubleshooting
