MINOLTA-QMS magicolor 6100 Series Service Manual page 262

7.5.11 Belt Marker Sensor (PBS)
Belt Sensor
Page 7-62
7.5.11.1 Tools
Phillips Screwdrivers #1 and #2
7.5.11.2 Disassembly Procedures
(see Fig. 7-56)
1. Remove the toner cartridges (see section 3.3.3).
2. Remove the belt cartridge (see section 3.3.2).
3. Remove the top cover (see section 7.1.5).
4. Remove the upper shield cover.
5. Remove one fixing screw (ST3x6) from the PBS Base.
6. Disconnect the connector from the belt marker sensor.
7. Remove the belt marker sensor from the PBS Base.
7.5.11.3 Assembly Procedures
1. Assemble the new belt marker sensor to the PBS Base.
2. Connect the harness connector with the belt marker sensor.
3. Reassemble in reverse order of disassembly.
PBS Base
Fig. 7-56
magicolor 6100 Series Service Manual