Table of Contents
Advertisement
7.6.5
magicolor 6100 Series Service Manual
Front Cover Unit
7.6.5.1
Tools
Phillips Screwdrivers #1 and #2
7.6.5.2
Disassembly Procedures
(see Fig. 7-66)
1. Open the front cover.
2. Remove the front cover (see section 7.1.13).
3. Disconnect four harness connectors from the front cover unit.
4. Remove one fixing screw (M3x6) from front cover unit hinge sup-
port.
5. Remove the hinge support from the frame.
6. Remove four fixing screws (M4x6) from the front cover unit supports
(2 each at left and right side).
7. Remove the front cover unit.
Hinge Support
7.6.5.3
Assembly Procedures
1. Attach the front cover unit support into the hole of engine side.
2. Secure the support from the rear side with the fixing screws (2 loca-
tions each at left and right side) with the front door closed.
3. Open the front door, and install the hinge support to the frame.
4. Tighten the remaining screws (2 locations at left and right sides) to
the front cover unit supports.
5. Reassemble in reverse order of disassembly.
14
Open/Close Support
Front Inner Cover
Front Cover Unit
Fig. 7-66
Page 7-73
Advertisement
Table of Contents
Troubleshooting
