MINOLTA-QMS magicolor 6100 Series Service Manual page 155

5.3.8
Paper Feeding Roller
Separator Pad
magicolor 6100 Series Service Manual
Checking of the Paper Feeding Roller and Separator Pad
5.3.8.1 Replacement Criteria
Since the paper feeding roller and separator pad are defined as periodic
replacement parts in Table 5-4, they should be replaced when frequent
misfeed jams occur.
5.3.8.2 Replacement Procedures
1. Whenever frequent misfeed jams occur, confirm that the cause is the
same as outlined in section 8.3, "Paper Transportation Errors."
1. If the feeding jam is caused by a paper feeding roller or separator pad,
replace them according to the replacement procedures set out in sec-
tion 7.6.4.
This procedure is a periodic replacement task, but it can-
not be done by the customer. This should be done by a
service technician upon request of the customer or at
periodic maintenance.
After the replacement, confirm the feeding of media such
as plain paper, OHP, and thick stock.
For proper performance of the optional lower feeding
unit (LFU), the following parts should be replaced as
noted.
Part Name
CAUTION
Part Code Replacement Cycle
825126142 Every 120k Prints
825126528 Every 120k Prints
Page 5-25