MINOLTA-QMS magicolor 6100 Series Service Manual page 271

7.6.3
magicolor 6100 Series Service Manual
Transfer Drum
7.6.3.1 Tools
Phillips Screwdrivers #1 and #2
7.6.3.2 Disassembly Procedures
(see Fig. 7-64)
1. Remove the toner cartridge.
2. Remove the belt cartridge.
3. Remove the fuser.
4. Remove the cleaner cover.
5. Remove the drum cleaner.
6. Open the transfer unit.
7. Remove the top cover (see
section 7.1.5).
8. Remove two set screws
(ST3x6) from stay 'A'.
9. Remove the stay 'A' assem-
bly.
10. Wrap the transfer drum with
paper so that it will not be
scratched.
11. Pull the transfer drum from the top side, and remove the transfer
drum from the shaft support.
12. Remove the transfer drum from the top.
7.6.3.3 Assembly Procedures
1. Install the new transfer drum into the printer from the top.
2. Position the transfer drum's shaft so that it meets the drum shaft sup-
port.
3. Push the transfer drum into the shaft support.
4. Install the stay 'A' assembly.
5. Reassemble in reverse order of disassembly.
Do not touch the transfer drum surface with your bare
hands. Do not scratch the surface of the drum.
Wrap transfer drum
surface with paper
CAUTION:
Transfer
Drum
Stay 'A' Assembly
Fig. 7-64
Page 7-71