MINOLTA-QMS magicolor 6100 Series Service Manual page 183

Step
Select NVM TUNE UP.
1
The LCD changes as shown in (a) ---> (b)
After selecting LP TUNE UP Code 1, press the Select
key.
2
The LCD changes as shown in (b) ---> (c)
After selecting the color to be altered, press the Select
key.
3
The LCD changes as shown in (c) ---> (d)
Tune Up value can be adjusted by 8 increments
between -4 and +4.
4
After selecting a given number, press the Select key.
The LCD changes as shown in (d)
Press the Media key to end this procedure for the
yellow toner.
5 The LCD changes as shown in (d) ---> (e)
Repeat steps 3 through 5 whenever adjustment is
required for each toner color.
Press the Media key to complete the tune-up work.
6
The LCD changes as shown in (e) ---> (f)
magicolor 6100 Series Service Manual
6.4.3.8.6.1
Table 6-18: LP Tune Up Procedure
Description of Procedure
LP Tune Up
Note: These are factory settings and should not
be changed.
This mode should be used when optical den-
sity, line thickness and/or color reproduction
need to be adjusted. The adjustment will be
made by changing the laser power against a
reference value 0 (zero) between a range of -4
and +4.
Message in LCD
39 FACTORY MODE
(a)
45 NVM TUNE UP
(b)
No.=< 1 2 3 4 5 6 7 8 9 >
45 LP TUNE UP
(c)
45 YELLOW
(d)
-< 4 3 2 1 0 1 2 3 4 >+
45 LP TUNE UP
(e)
45 NVM TUNE UP
(f )
No.=< 1 2 3 4 5 6 7 8 9 >
NVM TUNE UP
Y / M / C / K
[O]
Y / M / C / K
Page 6-27